Sears 200.713101 Manuel du propriétaire télécharger pdf (Page 6)

It is important that you read and follow these guidelineswhile you are preparingto

chargeyour battery.

• Make sure that you have a 12 volt or 6

volt lead-acid battery. Set the selector

switch to match the voltage rating of the

battery to be charged.

• Clean the battery terminals. Be careful

to keep corrosion from getting in or

around your eyes.

• For batteries with removable cell caps, if

required, add distilled water to each cell

until the battery acid reaches the level

recommended by the manufacturer.

This will help purge excessive gases

from the cells. Be careful not to overfill. If

you have a sealed battery without cell

caps, no action is necessary. Continue

to the next step listed below.

• Take time to read all battery

manufacturer's specific precautions,

cell caps while charging, and recom-

mended rates of charge.

• Wear safety glasses. See additional

"Personal Safety Precautions" on

page 4.

• Be sure that the area around the

battery is well ventilated while it is

being charged.

If it is necessary to remove the battery

from the vehicle to charge it, always

remove the grounded terminal from the

battery first. Turn off all vehicle

accessories to avoid sparks from

occurring.

NOTE: A marine battery installed in a

boat must be removed and charged on

shore.

such as removing or not removing

To obtain the best results from your battery charger, you must know how to use it

properly. This section will tell you how to set the controls, how to charge a battery in or

out of a vehicle, and how to use the engine st-arf feature.

SETTING THE CONTROLS

All controls are located on the front of

the charger. Follow these instructions

to obtain the correct charge level for

your battery.

SELECTOR SWITCHES:

Your charger has three switches:

• Use the left switch to match the

battery voltage--either 6 or 12 volt.

• Use the center switch to select a

charge type---MANUAL, AUTOMATIC

DEEP CYCLE or AUTOMATIC

REGULAR.

• Use the right switch to select a charge

rate---2 AMP charge, 10 AMP charge,

or 60 AMP ENGINE START.

Battery Voltage:

Select the voltage of your battery. The

most common applications will be 12 volt.

6 VOLT _ 12 VOLT

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Commentaires sur ces manuels

Pas de commentaire

Sears 200.713101 Manuel du propriétaire Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Chargeurs de batterie Sears 200.713101