Sears Clothes Dryer Manuel d'utilisateur télécharger pdf (Page 20)

SECTION 4

Lint Cleaning Instructions (con't)

If your dryer is gas and has a full front panel, remove front panel as follows:

This should be done only by a qualified person.

1. Unplug the power supply cord or

Remove screws before opening top

View A

Drum seal (see view D)

Side panel wire clips

^Front panel

wire clip

' (see view C)

Drum

Lower clip (see view B)

wrong

View D

turn off the electrical power.

2. Open lint screen lid. Remove two

screws in lint screen area.

3. Open top by pulling forward and up

at each front comer (see view A).

Rest raised top against wall behind

dryer (top is hinged at rear).

4. Remove two internal screws from

front panel flanges (near top front

comers). Lift front panel slightly,

lifting off lower clips (see view B).

Slowly pull front panel forward,

disengaging panel from drum.

(Drum will drop slightly.)

5. Move front panel aside and rest edge

against side of dryer. Avoid

disconnecting wire clips (see view C)

or damaging wires.

Remove lint from area shown in “gas

dryer” illustration on page 19 with

soft brush or vacuum cleaner. Avoid

damaging wires, funnel or igniter.

Reeissemble in reverse order. Befor

closing the top, check the following.

- Drum seal must be flared out

(see view D) and properly positioned

against panel at back of drum.

Rotate drum counterclockwise one

full turn to check drum seal.

- Belt should be centered and tight

on dryer drum.

- Wire clips which hold the door

switch wires must be anchored in

slot in top of front panel (see view

C) and along top edge of side

panel. Door wires must not touch

drum when dryer is operating.

See warning page 19.

8. Replace top panel and lint screen

screws. Top and front panels must

be securely in place before operating

dryer.

9. Reconnect power and level dryer

again (if necessary).

6.

7.

20

1 2 ... 15 16 17 18 19 20 21 22 23 24

Commentaires sur ces manuels

Pas de commentaire