INSTALLATION STEP 10
Connect Door Arm to Trolley
Follow only those instructions which apply to
your door type.
SECTIONAL DOORS ONLY
Make sure garage door is closed tight. Pull the emergency release handle to disconnect the trolley.
Manually move outer trolley back to the center of inner trolley as shown in figures A, B and C.
FIG. A: Fasten straight door arm section to outer
trolley with a clevis pin. Secure the connection with a
ring fastener.
Fasten curved section to the door bracket in the
same way.
FIG. B: Bring arm sections together. Find two pairs of
holes that line up and join sections.
Select holes as far apart as possible to increase door
arm rigidity.
FIG. C: If holes in curved arm are ABOVE holes in
straight arm, disconnect straight arm. Cut about 6"
from the solid end. Reconnect to trolley with CUT
END DOWN as shown.
Bring arm sections together. Find two pairs of holes
that line up and join with screws, lock washers and
nuts.
18
Proceed to Step 1, page 20. Trolley will re-engage automatically when opener is operated
Ring
Fastener
Door
Bracket
Clevis Pin
Curved
Door Arm
Straight
Door Arm
Clevis
Pin
A
Lock
Washers
5/16"
Nuts
5/16"-18
Door
Bracket
Screws
5/16"-18x7/8"
Emergency
Release
Handle
Rope
B
C
Rin
Fast
Straight
Door Arm
Screws
5/16"-18x7
Door
Bracket
Clevis Pin
Fully Closed
Trolley
gency
ease
ndle
Lock
Washers
5/16"
Nuts
5/16"-18
Screws
5/16"-18x7/8"
Cut This End
C
Commentaires sur ces manuels