Sears 139.53975SRT1 Manuel du propriétaire télécharger pdf (Page 25)

ONE-PIECEDOORS

Please read and comply with the warnings and

reinforcement instructionson the previous page.

They apply to one-piece doors also.

• Center the door bracket on the top of the door, in

line with the header bracket as shown. Mark either

the left and right, or the top and bottom holes.

• Drill 5/16" pilot holes and fasten the bracket with

hardware supplied.

If the door has no exposed framing, drill 3/16" pilot

holes and fasten the bracket with 5/16"x1-1/2" lag

screws (not provided) to the top of the door.

NOTE: The door bracket may be installed on the top

edge of the door if required for your installation.

(Refer to the dotted line optional placement drawing.)

Drill 3/16" pilot holes and substitute 5/16"xl-1/2" lag

screws (not provided) to fasten the bracket to the

door.

HARDWARE SHOWN ACTUAL SIZE

Nut 5/16"_18 Loekwasher 5/16"

Carriage Bolt

5/f 6"-f 8x2q/2"

Header Wall

2x4Suppo_

Finished Ceiling

Horizontal and verlical

reinforcement is needed for

lightweight garage doors

(fiberglass, aluminum, steel,

door with glass panel, etc.)

(not provided).

For a door with no exposed framing,

or for the optional installation, use

5/f 6"xlq/2" lag screws (not provided)

to fasten door bracket.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 75 76

Pas de commentaire

Sears 139.53975SRT1 Manuel du propriétaire Page 25