Sears 113.23611 Manuel d'utilisateur télécharger pdf (Page 16)

maintenance

WARNING; FOR YOUR OWN SAFETY, TURN SWITCH

“OFF", REMOVE KEY AND REMOVE PLUG FROM POWER

SOURCE OUTLET BEFORE MAINTAINING OR LUBRI

CATING YOUR SAW.

GENERAL

An occasional coat of paste wax on the work table will allow

the wood being cut to glide smoothly across the work surface.

MOTOR

If the power cord is wortt, cut, or damaged in any way, have

it replaced immediately.

Do not attempt to oil the motor bearings or service the motor

internal parts.

ARM BEARINGS

Lubricate the arm bearings after 10 hours of use. Re-oil after

every 50 hours of use or whenever there is a squeak coming

from the bearings. Four plastic bearing caps are provided with

this saw. Add SAE 20 oil into each cap and then snap cap onto

arm bearing. Leave caps on bearings for overnight and then

remove and store caps for later use.

ALTERNATE METHOD OF OILING BEARINGS IF

RE-OIL CAPS ARE LOST.

1. Turn saw on its side.

2. Squirt a generous amount of SAE 20 oil around the shaft

end and bronze bearing.

3. Let the oil soak in overnight in this condition.

4. Next day; repeat the above procedure tor the opposite side

of the saw.

1 2 ... 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Sears 113.23611 Manuel d'utilisateur Page 16