Sears LS elite 780 Manuel du propriétaire télécharger pdf (Page 6)

ASSEMBLY

Assembly requires the assistance Of a second person. Set the treadmill in a cleared area and remove all

packing materials. Do not dispose of the packing materials until assembly is completed. THE FOLLOWING

TOOLS ARE REQUIRED FOR ASSEMBLY: An adjustable wrench _ (not included).

Find the Right Updght (15) (see the inset drawing to identify the

Right Updght). Insert a 3/8" x 3 1/2" Bolt (27), with one of the

four Upright Washers (26), into the higher hole in the bottom of

the Right Upright. Slide one of the two Star Washers (107) onto

the Bolt. Finger tighten the Bolt into the indicated hole in the

side of the Frame (50). Hold an Upright Spacer (48) inside the

bottom of the Right Upright. Insert a 3/8" x 3 1/2" Bolt (27), with

an Updght Washer (26), through the lower hole in the bottom of

the Right Upright and the Spacer. Finger tighten the Bolt into

the indicated hole in the Frame.

Attach the Left Upright (not shown) in the same manner.

2. Hold the Console Crossbar (6) near the Right Upright (15).

Connect the Console Wire Harness (10) to the Updght Wire

Harness (12). The small latch on the Console Wire Harness

should snap onto the Upright Wire Harness (see the inset draw-

ing). If the Wire Harnesses do not fit easily, turn them; do not

force the Wire Harnesses together.

Adjust the 24" Cable Loom (11) and6" Cable Loom (30) so that

the ends of the Wire Hamesses (10, 12) are covered. Insert the

Cable Looms into the Right Updght (15). Be careful not to

damage the Wire Harnesses.

11 12

Slide the Console Crossbar (6) into the Right Upright (15).

Rotate the Console Crossbar to the desired angle. Tighten a

Console Knob (3) into the Console Crossbar.

Push an Upright Endcap (4) into the end of the Right Upright

(15).

15 3

4. Slide the Console Crossbar (6) into the Left Upright (2). Tighten

a Console Knob (3) into the Console Crossbar.

Push an Upright Endcap (4) into the end of the Left Upright (2).

Using an adjustable wrench, tighten the four 3/8" x 3 1/2" Bolts

(27) used in assembly step 1 (see assembly step 1).

1 2 3 4 5 6 7 8 9 10 11 ... 20 21

Pas de commentaire

Sears LS elite 780 Manuel du propriétaire Page 6