Sears SRD2900 Manuel d'instructions télécharger pdf (Page 17)

SETUP

The VCR can automatically program the tuner to scan

only the channels which are available in your area.

oChannel memory programming is NOT needed

when the VCR is connected to a cable box or a satel-

lite box as in "DVD/VCR TO TV CONNECTION"

on page 14. In this case, set the CH3/CH4 Switch

(which is located on the back of your VCR) to either

CH3 or CH4, whichever is not used for normal

broadcasts in your area. Then set your TV to the

same channel. The channel you want to record or

view will be selected from the cable or the satellite

box.

• Follow the steps below once. Repeat only if there is

a power failure or if the VCR is unplugged for more

than 30 seconds. (In these cases, the programmed

channels are erased.)

• You must follow the steps below before attempting to

play or record a video tape.

1 You need to connect the antenna or cable to

the VCR first. Then, connect the DVD /VCR

power plug to a standard AC outlet.

2 Turn on theTV and set the TV to channel 3 or

• Now set the CH3/CH4 switch on the back of the

VCR to match the channel selected on the TV.

3 Turn on the VCR by pressing the POWER but-

ton. Both the POWER and the VCR/TV light

will come on.

Select the On Screen Language ("ENGLISH",

"FRANCAIS" or "ESPAI_IOL") by pressing the

PLAY or the STOP button.

LANGUAGE St'LECT 1

Then, press the F.FWD but- -- --

I1_ ENGLISH ION1

ton.

FRANCAIS

ESPANOL

5 Begin channel preset by pressing the F.FWD

button once, The tuner scans and memorizes

all active channels in your area,

• The VCR distinguishes between

standard TV channels and cable

channels.

CH01}

AUTO SET UP _

6 After scanning, the tuner stops on the lowest

memorized channeI.TbeTV screen returns to

TV mode.

• If "AUTO SET UP" appears on the TV screen again,

check the cable connections. Press the EFWD but-

ton once again and the VCR will begin preset again.

TO SELECT A DESIRED CHANNEL

You can select the desired channel by using the

CHANNEL buttons (A/v) or by directly pressing the

Number buttons on the remote control.

Note for using the Number buttons:

• When selecting cable channels which are higher than

99, press the +100 button first, then press the last two

digits.

• You must precede single-digit channel numbers with

a zero (For example: 02, 03, 04 and so on).

TO PRESET THE CHANNELS AGAIN

Press the MENU button until the main menu

appears. (If you have already set the clock,

you only have to press it once. If not, you

have to press it twice).

2 Select "CHANNEL SET UP" by pressing the

PLAY or the STOP button. Then, press the

F.FWD button.

3 Select"AUTO SET UP" by pressing the PLAY

or the STOP button. Then, press the F.FWD

button.

• After scanning, the tuner stops on the lowest memo-

rized channel.

- 17 - EN

IL25

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Sears SRD2900 Manuel d'instructions Page 17

Commentaires sur ces manuels

Produits connexes et manuels pour Lecteurs de DVD Sears SRD2900